pm24.git/drivers/char, branch v5.8-rc5

Revert commit e918e570415c ("tpm_tis: Remove the HID IFX0102")

2020-07-07T01:25:17Z

Removing IFX0102 from tpm_tis was not a right move because both tpm_tis and tpm_infineon use the same device ID. Revert the commit and add a remark about a bug caused by commit 93e1b7d42e1e ("[PATCH] tpm: add HID module parameter"). Fixes: e918e570415c ("tpm_tis: Remove the HID IFX0102") Reported-by: Peter Huewe Reviewed-by: Jerry Snitselaar Signed-off-by: Jarkko Sakkinen

tpm_tis: Remove the HID IFX0102

2020-07-02T14:49:00Z

Acer C720 running Linux v5.3 reports this in klog: tpm_tis: 1.2 TPM (device-id 0xB, rev-id 16) tpm tpm0: tpm_try_transmit: send(): error -5 tpm tpm0: A TPM error (-5) occurred attempting to determine the timeouts tpm_tis tpm_tis: Could not get TPM timeouts and durations tpm_tis 00:08: 1.2 TPM (device-id 0xB, rev-id 16) tpm tpm0: tpm_try_transmit: send(): error -5 tpm tpm0: A TPM error (-5) occurred attempting to determine the timeouts tpm_tis 00:08: Could not get TPM timeouts and durations ima: No TPM chip found, activating TPM-bypass! tpm_inf_pnp 00:08: Found TPM with ID IFX0102 % git --no-pager grep IFX0102 drivers/char/tpm drivers/char/tpm/tpm_infineon.c: {"IFX0102", 0}, drivers/char/tpm/tpm_tis.c: {"IFX0102", 0}, /* Infineon */ Obviously IFX0102 was added to the HID table for the TCG TIS driver by mistake. Fixes: 93e1b7d42e1e ("[PATCH] tpm: add HID module parameter") Link: https://bugzilla.kernel.org/show_bug.cgi?id=203877 Cc: stable@vger.kernel.org Cc: Kylene Jo Hall Reported-by: Ferry Toth: Reviewed-by: Jerry Snitselaar Signed-off-by: Jarkko Sakkinen

tpm_tis_spi: Prefer async probe

2020-07-02T14:49:00Z

On a Chromebook I'm working on I noticed a big (~1 second) delay during bootup where nothing was happening. Right around this big delay there were messages about the TPM: [ 2.311352] tpm_tis_spi spi0.0: TPM ready IRQ confirmed on attempt 2 [ 3.332790] tpm_tis_spi spi0.0: Cr50 firmware version: ... I put a few printouts in and saw that tpm_tis_spi_init() (specifically tpm_chip_register() in that function) was taking the lion's share of this time, though ~115 ms of the time was in cr50_print_fw_version(). Let's make a one-line change to prefer async probe for tpm_tis_spi. There's no reason we need to block other drivers from probing while we load. NOTES: * It's possible that other hardware runs through the init sequence faster than Cr50 and this isn't such a big problem for them. However, even if they are faster they are still doing _some_ transfers over a SPI bus so this should benefit everyone even if to a lesser extent. * It's possible that there are extra delays in the code that could be optimized out. I didn't dig since once I enabled async probe they no longer impacted me. Signed-off-by: Douglas Anderson Reviewed-by: Jarkko Sakkinen Signed-off-by: Jarkko Sakkinen

tpm: ibmvtpm: Wait for ready buffer before probing for TPM2 attributes

2020-07-02T14:49:00Z

The tpm2_get_cc_attrs_tbl() call will result in TPM commands being issued, which will need the use of the internal command/response buffer. But, we're issuing this *before* we've waited to make sure that buffer is allocated. This can result in intermittent failures to probe if the hypervisor / TPM implementation doesn't respond quickly enough. I find it fails almost every time with an 8 vcpu guest under KVM with software emulated TPM. To fix it, just move the tpm2_get_cc_attrs_tlb() call after the existing code to wait for initialization, which will ensure the buffer is allocated. Fixes: 18b3670d79ae9 ("tpm: ibmvtpm: Add support for TPM2") Signed-off-by: David Gibson Reviewed-by: Jerry Snitselaar Reviewed-by: Jarkko Sakkinen Signed-off-by: Jarkko Sakkinen

tpm/st33zp24: fix spelling mistake "drescription" -> "description"

2020-07-02T14:49:00Z

Trivial fix, the spelling of "drescription" is incorrect in function comment. Fix this. Signed-off-by: Binbin Zhou Acked-by: Jarkko Sakkinen Signed-off-by: Jarkko Sakkinen

tpm_tis: extra chip->ops check on error path in tpm_tis_core_init

2020-07-02T14:49:00Z

Found by smatch: drivers/char/tpm/tpm_tis_core.c:1088 tpm_tis_core_init() warn: variable dereferenced before check 'chip->ops' (see line 979) 'chip->ops' is assigned in the beginning of function in tpmm_chip_alloc->tpm_chip_alloc and is used before first possible goto to error path. Signed-off-by: Vasily Averin Reviewed-by: Jerry Snitselaar Reviewed-by: Jarkko Sakkinen Signed-off-by: Jarkko Sakkinen

tpm_tis_spi: Don't send anything during flow control

2020-07-02T14:48:59Z

During flow control we are just reading from the TPM, yet our spi_xfer has the tx_buf and rx_buf both non-NULL which means we're requesting a full duplex transfer. SPI is always somewhat of a full duplex protocol anyway and in theory the other side shouldn't really be looking at what we're sending it during flow control, but it's still a bit ugly to be sending some "random" data when we shouldn't. The default tpm_tis_spi_flow_control() tries to address this by setting 'phy->iobuf[0] = 0'. This partially avoids the problem of sending "random" data, but since our tx_buf and rx_buf both point to the same place I believe there is the potential of us sending the TPM's previous byte back to it if we hit the retry loop. Another flow control implementation, cr50_spi_flow_control(), doesn't address this at all. Let's clean this up and just make the tx_buf NULL before we call flow_control(). Not only does this ensure that we're not sending any "random" bytes but it also possibly could make the SPI controller behave in a slightly more optimal way. NOTE: no actual observed problems are fixed by this patch--it's was just made based on code inspection. Signed-off-by: Douglas Anderson Reviewed-by: Paul Menzel Reviewed-by: Jarkko Sakkinen Signed-off-by: Jarkko Sakkinen

tpm: Fix TIS locality timeout problems

2020-07-02T14:48:59Z

It has been reported that some TIS based TPMs are giving unexpected errors when using the O_NONBLOCK path of the TPM device. The problem is that some TPMs don't like it when you get and then relinquish a locality (as the tpm_try_get_ops()/tpm_put_ops() pair does) without sending a command. This currently happens all the time in the O_NONBLOCK write path. Fix this by moving the tpm_try_get_ops() further down the code to after the O_NONBLOCK determination is made. This is safe because the priv->buffer_mutex still protects the priv state being modified. BugLink: https://bugzilla.kernel.org/show_bug.cgi?id=206275 Fixes: d23d12484307 ("tpm: fix invalid locking in NONBLOCKING mode") Reported-by: Mario Limonciello Tested-by: Alex Guzman Cc: stable@vger.kernel.org Reviewed-by: Jerry Snitselaar Signed-off-by: James Bottomley Reviewed-by: Jarkko Sakkinen Signed-off-by: Jarkko Sakkinen

Merge branch 'linus' of git://git.kernel.org/pub/scm/linux/kernel/git/herbert/crypto-2.6

2020-06-21T17:01:03Z

Pull crypto fixes from Herbert Xu: - NULL dereference in octeontx - PM reference imbalance in ks-sa - deadlock in crypto manager - memory leak in drbg - missing socket limit check on receive SG list size in algif_skcipher - typos in caam - warnings in ccp and hisilicon * 'linus' of git://git.kernel.org/pub/scm/linux/kernel/git/herbert/crypto-2.6: crypto: drbg - always try to free Jitter RNG instance crypto: marvell/octeontx - Fix a potential NULL dereference crypto: algboss - don't wait during notifier callback crypto: caam - fix typos crypto: ccp - Fix sparse warnings in sev-dev crypto: hisilicon - Cap block size at 2^31 crypto: algif_skcipher - Cap recv SG list at ctx->used hwrng: ks-sa - Fix runtime PM imbalance on error

maccess: rename probe_kernel_{read,write} to copy_{from,to}_kernel_nofault

2020-06-17T17:57:41Z

Better describe what these functions do. Suggested-by: Linus Torvalds Signed-off-by: Christoph Hellwig Signed-off-by: Linus Torvalds