pm24.git/drivers/tee/optee, branch v5.9

Merge tag 'optee-bus-for-v5.9' of git://git.linaro.org/people/jens.wiklander/linux-tee into arm/drivers

2020-07-13T13:11:44Z

Enable multi-stage OP-TEE bus enumeration Probes drivers on the OP-TEE bus in two steps. First for drivers which do not depend on tee-supplicant. After tee-supplicant has been started probe the devices which do depend on tee-supplicant. Also introduces driver which uses an OP-TEE based fTPM Trusted Application depends on tee-supplicant NV RAM implementation based on RPMB secure storage. * tag 'optee-bus-for-v5.9' of git://git.linaro.org/people/jens.wiklander/linux-tee: tpm_ftpm_tee: register driver on TEE bus optee: enable support for multi-stage bus enumeration optee: use uuid for sysfs driver entry Link: https://lore.kernel.org/r/20200710085230.GA1312913@jade Signed-off-by: Arnd Bergmann

optee: enable support for multi-stage bus enumeration

2020-07-10T07:41:53Z

Some drivers (like ftpm) can operate only after tee-supplicant runs because of tee-supplicant provides things like storage services (rpmb, shm). This patch splits probe of non tee-supplicant dependable drivers to the early stage, and after tee-supplicant run probe other drivers. Signed-off-by: Maxim Uvarov Suggested-by: Sumit Garg Suggested-by: Arnd Bergmann Reviewed-by: Sumit Garg Acked-by: Jarkko Sakkinen Tested-by: Sumit Garg Signed-off-by: Jens Wiklander

optee: use uuid for sysfs driver entry

2020-07-10T07:41:48Z

With the evolving use-cases for TEE bus, now it's required to support multi-stage enumeration process. But using a simple index doesn't suffice this requirement and instead leads to duplicate sysfs entries. So instead switch to use more informative device UUID for sysfs entry like: /sys/bus/tee/devices/optee-ta- Signed-off-by: Maxim Uvarov Reviewed-by: Sumit Garg Reviewed-by: Jarkko Sakkinen Tested-by: Sumit Garg Signed-off-by: Jens Wiklander

mmap locking API: use coccinelle to convert mmap_sem rwsem call sites

2020-06-09T16:39:14Z

This change converts the existing mmap_sem rwsem calls to use the new mmap locking API instead. The change is generated using coccinelle with the following rule: // spatch --sp-file mmap_lock_api.cocci --in-place --include-headers --dir . @@ expression mm; @@ ( -init_rwsem +mmap_init_lock | -down_write +mmap_write_lock | -down_write_killable +mmap_write_lock_killable | -down_write_trylock +mmap_write_trylock | -up_write +mmap_write_unlock | -downgrade_write +mmap_write_downgrade | -down_read +mmap_read_lock | -down_read_killable +mmap_read_lock_killable | -down_read_trylock +mmap_read_trylock | -up_read +mmap_read_unlock ) -(&mm->mmap_sem) +(mm) Signed-off-by: Michel Lespinasse Signed-off-by: Andrew Morton Reviewed-by: Daniel Jordan Reviewed-by: Laurent Dufour Reviewed-by: Vlastimil Babka Cc: Davidlohr Bueso Cc: David Rientjes Cc: Hugh Dickins Cc: Jason Gunthorpe Cc: Jerome Glisse Cc: John Hubbard Cc: Liam Howlett Cc: Matthew Wilcox Cc: Peter Zijlstra Cc: Ying Han Link: http://lkml.kernel.org/r/20200520052908.204642-5-walken@google.com Signed-off-by: Linus Torvalds

tee: optee: Add support for session login client UUID generation

2020-05-11T12:11:33Z

Adds support for client UUID generation for OP-TEE. For group based session logins membership is verified. Signed-off-by: Vesa Jääskeläinen Signed-off-by: Jens Wiklander

Merge tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

2020-02-08T22:04:19Z

Pull ARM SoC-related driver updates from Olof Johansson: "Various driver updates for platforms: - Nvidia: Fuse support for Tegra194, continued memory controller pieces for Tegra30 - NXP/FSL: Refactorings of QuickEngine drivers to support ARM/ARM64/PPC - NXP/FSL: i.MX8MP SoC driver pieces - TI Keystone: ring accelerator driver - Qualcomm: SCM driver cleanup/refactoring + support for new SoCs. - Xilinx ZynqMP: feature checking interface for firmware. Mailbox communication for power management - Overall support patch set for cpuidle on more complex hierarchies (PSCI-based) and misc cleanups, refactorings of Marvell, TI, other platforms" * tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (166 commits) drivers: soc: xilinx: Use mailbox IPI callback dt-bindings: power: reset: xilinx: Add bindings for ipi mailbox drivers: soc: ti: knav_qmss_queue: Pass lockdep expression to RCU lists MAINTAINERS: Add brcmstb PCIe controller entry soc/tegra: fuse: Unmap registers once they are not needed anymore soc/tegra: fuse: Correct straps' address for older Tegra124 device trees soc/tegra: fuse: Warn if straps are not ready soc/tegra: fuse: Cache values of straps and Chip ID registers memory: tegra30-emc: Correct error message for timed out auto calibration memory: tegra30-emc: Firm up hardware programming sequence memory: tegra30-emc: Firm up suspend/resume sequence soc/tegra: regulators: Do nothing if voltage is unchanged memory: tegra: Correct reset value of xusb_hostr soc/tegra: fuse: Add APB DMA dependency for Tegra20 bus: tegra-aconnect: Remove PM_CLK dependency dt-bindings: mediatek: add MT6765 power dt-bindings soc: mediatek: cmdq: delete not used define memory: tegra: Add support for the Tegra194 memory controller memory: tegra: Only include support for enabled SoCs memory: tegra: Support DVFS on Tegra186 and later ...

Merge tag 'tee-optee-fix2-for-5.5' of https://git.linaro.org:/people/jens.wiklander/linux-tee into arm/fixes

2020-01-24T20:05:08Z

Fix OP-TEE compile error with nommu * tag 'tee-optee-fix2-for-5.5' of https://git.linaro.org:/people/jens.wiklander/linux-tee: tee: optee: Fix compilation issue with nommu Link: https://lore.kernel.org/r/20200123101310.GA10320@jax Signed-off-by: Olof Johansson

tee: optee: Fix compilation issue with nommu

2020-01-23T09:55:20Z

The optee driver uses specific page table types to verify if a memory region is normal. These types are not defined in nommu systems. Trying to compile the driver in these systems results in a build error: linux/drivers/tee/optee/call.c: In function ‘is_normal_memory’: linux/drivers/tee/optee/call.c:533:26: error: ‘L_PTE_MT_MASK’ undeclared (first use in this function); did you mean ‘PREEMPT_MASK’? return (pgprot_val(p) & L_PTE_MT_MASK) == L_PTE_MT_WRITEALLOC; ^~~~~~~~~~~~~ PREEMPT_MASK linux/drivers/tee/optee/call.c:533:26: note: each undeclared identifier is reported only once for each function it appears in linux/drivers/tee/optee/call.c:533:44: error: ‘L_PTE_MT_WRITEALLOC’ undeclared (first use in this function) return (pgprot_val(p) & L_PTE_MT_MASK) == L_PTE_MT_WRITEALLOC; ^~~~~~~~~~~~~~~~~~~ Make the optee driver depend on MMU to fix the compilation issue. Signed-off-by: Vincenzo Frascino [jw: update commit title] Signed-off-by: Jens Wiklander

optee: Fix multi page dynamic shm pool alloc

2020-01-03T10:21:12Z

optee_shm_register() expected pages to be passed as an array of page pointers rather than as an array of contiguous pages. So fix that via correctly passing pages as per expectation. Fixes: a249dd200d03 ("tee: optee: Fix dynamic shm pool allocations") Reported-by: Vincent Cao Signed-off-by: Sumit Garg Tested-by: Vincent Cao Signed-off-by: Jens Wiklander

optee: model OP-TEE as a platform device/driver

2020-01-03T08:26:40Z

To simplify adding ACPI support to the OP-TEE driver, model it as a platform driver. This will permit us to use the generic device property layer for parsing additional properties, regardless of whether DT or ACPI is being used. Note that this change will result in the OP-TEE driver to be loaded automatically on systems that advertise the presence of OP-TEE via the device tree. Acked-by: Sumit Garg Signed-off-by: Ard Biesheuvel Signed-off-by: Jens Wiklander