diff options
| -rw-r--r-- | arch/arm/boot/dts/armada-xp-linksys-mamba.dts | 5 | ||||
| -rw-r--r-- | drivers/bus/mvebu-mbus.c | 109 |
2 files changed, 24 insertions, 90 deletions
diff --git a/arch/arm/boot/dts/armada-xp-linksys-mamba.dts b/arch/arm/boot/dts/armada-xp-linksys-mamba.dts index a2cf2154dcdb..fdd187c55aa5 100644 --- a/arch/arm/boot/dts/armada-xp-linksys-mamba.dts +++ b/arch/arm/boot/dts/armada-xp-linksys-mamba.dts @@ -95,6 +95,11 @@ internal-regs { + rtc@10300 { + /* No crystal connected to the internal RTC */ + status = "disabled"; + }; + /* J10: VCC, NC, RX, NC, TX, GND */ serial@12000 { status = "okay"; diff --git a/drivers/bus/mvebu-mbus.c b/drivers/bus/mvebu-mbus.c index fb9ec6221730..6f047dcb94c2 100644 --- a/drivers/bus/mvebu-mbus.c +++ b/drivers/bus/mvebu-mbus.c @@ -58,7 +58,6 @@ #include <linux/debugfs.h> #include <linux/log2.h> #include <linux/syscore_ops.h> -#include <linux/memblock.h> /* * DDR target is the same on all platforms. @@ -70,6 +69,7 @@ */ #define WIN_CTRL_OFF 0x0000 #define WIN_CTRL_ENABLE BIT(0) +/* Only on HW I/O coherency capable platforms */ #define WIN_CTRL_SYNCBARRIER BIT(1) #define WIN_CTRL_TGT_MASK 0xf0 #define WIN_CTRL_TGT_SHIFT 4 @@ -102,9 +102,7 @@ /* Relative to mbusbridge_base */ #define MBUS_BRIDGE_CTRL_OFF 0x0 -#define MBUS_BRIDGE_SIZE_MASK 0xffff0000 #define MBUS_BRIDGE_BASE_OFF 0x4 -#define MBUS_BRIDGE_BASE_MASK 0xffff0000 /* Maximum number of windows, for all known platforms */ #define MBUS_WINS_MAX 20 @@ -323,8 +321,9 @@ static int mvebu_mbus_setup_window(struct mvebu_mbus_state *mbus, ctrl = ((size - 1) & WIN_CTRL_SIZE_MASK) | (attr << WIN_CTRL_ATTR_SHIFT) | (target << WIN_CTRL_TGT_SHIFT) | - WIN_CTRL_SYNCBARRIER | WIN_CTRL_ENABLE; + if (mbus->hw_io_coherency) + ctrl |= WIN_CTRL_SYNCBARRIER; writel(base & WIN_BASE_LOW, addr + WIN_BASE_OFF); writel(ctrl, addr + WIN_CTRL_OFF); @@ -577,106 +576,36 @@ static unsigned int armada_xp_mbus_win_remap_offset(int win) return MVEBU_MBUS_NO_REMAP; } -/* - * Use the memblock information to find the MBus bridge hole in the - * physical address space. - */ -static void __init -mvebu_mbus_find_bridge_hole(uint64_t *start, uint64_t *end) -{ - struct memblock_region *r; - uint64_t s = 0; - - for_each_memblock(memory, r) { - /* - * This part of the memory is above 4 GB, so we don't - * care for the MBus bridge hole. - */ - if (r->base >= 0x100000000) - continue; - - /* - * The MBus bridge hole is at the end of the RAM under - * the 4 GB limit. - */ - if (r->base + r->size > s) - s = r->base + r->size; - } - - *start = s; - *end = 0x100000000; -} - static void __init mvebu_mbus_default_setup_cpu_target(struct mvebu_mbus_state *mbus) { int i; int cs; - uint64_t mbus_bridge_base, mbus_bridge_end; mvebu_mbus_dram_info.mbus_dram_target_id = TARGET_DDR; - mvebu_mbus_find_bridge_hole(&mbus_bridge_base, &mbus_bridge_end); - for (i = 0, cs = 0; i < 4; i++) { - u64 base = readl(mbus->sdramwins_base + DDR_BASE_CS_OFF(i)); - u64 size = readl(mbus->sdramwins_base + DDR_SIZE_CS_OFF(i)); - u64 end; - struct mbus_dram_window *w; - - /* Ignore entries that are not enabled */ - if (!(size & DDR_SIZE_ENABLED)) - continue; - - /* - * Ignore entries whose base address is above 2^32, - * since devices cannot DMA to such high addresses - */ - if (base & DDR_BASE_CS_HIGH_MASK) - continue; - - base = base & DDR_BASE_CS_LOW_MASK; - size = (size | ~DDR_SIZE_MASK) + 1; - end = base + size; - - /* - * Adjust base/size of the current CS to make sure it - * doesn't overlap with the MBus bridge hole. This is - * particularly important for devices that do DMA from - * DRAM to a SRAM mapped in a MBus window, such as the - * CESA cryptographic engine. - */ + u32 base = readl(mbus->sdramwins_base + DDR_BASE_CS_OFF(i)); + u32 size = readl(mbus->sdramwins_base + DDR_SIZE_CS_OFF(i)); /* - * The CS is fully enclosed inside the MBus bridge - * area, so ignore it. + * We only take care of entries for which the chip + * select is enabled, and that don't have high base + * address bits set (devices can only access the first + * 32 bits of the memory). */ - if (base >= mbus_bridge_base && end <= mbus_bridge_end) - continue; + if ((size & DDR_SIZE_ENABLED) && + !(base & DDR_BASE_CS_HIGH_MASK)) { + struct mbus_dram_window *w; - /* - * Beginning of CS overlaps with end of MBus, raise CS - * base address, and shrink its size. - */ - if (base >= mbus_bridge_base && end > mbus_bridge_end) { - size -= mbus_bridge_end - base; - base = mbus_bridge_end; + w = &mvebu_mbus_dram_info.cs[cs++]; + w->cs_index = i; + w->mbus_attr = 0xf & ~(1 << i); + if (mbus->hw_io_coherency) + w->mbus_attr |= ATTR_HW_COHERENCY; + w->base = base & DDR_BASE_CS_LOW_MASK; + w->size = (size | ~DDR_SIZE_MASK) + 1; } - - /* - * End of CS overlaps with beginning of MBus, shrink - * CS size. - */ - if (base < mbus_bridge_base && end > mbus_bridge_base) - size -= end - mbus_bridge_base; - - w = &mvebu_mbus_dram_info.cs[cs++]; - w->cs_index = i; - w->mbus_attr = 0xf & ~(1 << i); - if (mbus->hw_io_coherency) - w->mbus_attr |= ATTR_HW_COHERENCY; - w->base = base; - w->size = size; } mvebu_mbus_dram_info.num_cs = cs; } |