| Age | Commit message (Collapse) | Author |
|---|
|
Make sure that the bus and codecs are pm_runtime active when the card
is registered/created. This avoid timeouts when accessing registers.
BugLink: https://github.com/thesofproject/linux/issues/3651
BugLink: https://github.com/thesofproject/linux/issues/3650
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Rander Wang <rander.wang@intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Reviewed-by: Bard Liao <yung-chuan.liao@linux.intel.com>
Reviewed-by: Péter Ujfalusi <peter.ujfalusi@linux.intel.com>
Link: https://lore.kernel.org/r/20220616210825.132093-3-pierre-louis.bossart@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
When binding/unbinding codec drivers, the following warnings are
thrown:
[ 107.266879] rt715-sdca sdw:3:025d:0714:01: Unbalanced pm_runtime_enable!
[ 306.879700] rt711-sdca sdw:0:025d:0711:01: Unbalanced pm_runtime_enable!
Add a remove callback for all Realtek/Maxim SoundWire codecs and remove this
warning.
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Rander Wang <rander.wang@intel.com>
Reviewed-by: Bard Liao <yung-chuan.liao@linux.intel.com>
Link: https://lore.kernel.org/r/20220606203752.144159-2-pierre-louis.bossart@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
The endianness flag is used on the CODEC side to specify an
ambivalence to endian, typically because it is lost over the hardware
link. This device receives audio over a SoundWire DAI and as such
should have endianness applied.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20220504170905.332415-36-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
The HDAudio ASoC support relies on the set_tdm_slots() helper to store
the HDaudio stream tag in the tx_mask. This only works because of the
pre-existing order in soc-pcm.c, where the hw_params() is handled for
codec_dais *before* cpu_dais. When the order is reversed, the
stream_tag is used as a mask in the codec fixup functions:
/* fixup params based on TDM slot masks */
if (substream->stream == SNDRV_PCM_STREAM_PLAYBACK &&
codec_dai->tx_mask)
soc_pcm_codec_params_fixup(&codec_params,
codec_dai->tx_mask);
As a result of this confusion, the codec_params_fixup() ends-up
generating bad channel masks, depending on what stream_tag was
allocated.
We could add a flag to state that the tx_mask is really not a mask,
but it would be quite ugly to persist in overloading concepts.
Instead, this patch suggests a more generic get/set 'stream' API based
on the existing model for SoundWire. We can expand the concept to
store 'stream' opaque information that is specific to different DAI
types. In the case of HDAudio DAIs, we only need to store a stream tag
as an unsigned char pointer. The TDM rx_ and tx_masks should really
only be used to store masks.
Rename get_sdw_stream/set_sdw_stream callbacks and helpers as
get_stream/set_stream. No functionality change beyond the rename.
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Rander Wang <rander.wang@intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@intel.com>
Signed-off-by: Bard Liao <yung-chuan.liao@linux.intel.com>
Acked-By: Vinod Koul <vkoul@kernel.org>
Link: https://lore.kernel.org/r/20211224021034.26635-5-yung-chuan.liao@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
The intent of the status check on resume was to verify if a SoundWire
peripheral reported ATTACHED before waiting for the initialization to
complete. This is required to avoid timeouts that will happen with
'ghost' devices that are exposed in the platform firmware but are not
populated in hardware.
Unfortunately we used 'hw_init' instead of 'first_hw_init'. Due to
another error, the resume operation never timed out, but the volume
settings were not properly restored.
BugLink: https://github.com/thesofproject/linux/issues/2908
BugLink: https://github.com/thesofproject/linux/issues/2637
Fixes: 2b719fd20f327 ('ASoC: rt1316: Add RT1316 SDCA vendor-specific driver')
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Guennadi Liakhovetski <guennadi.liakhovetski@linux.intel.com>
Reviewed-by: Bard Liao <bard.liao@intel.com>
Link: https://lore.kernel.org/r/20210607222239.582139-5-pierre-louis.bossart@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
In case of error, the function devm_regmap_init_sdw() returns ERR_PTR()
and never returns NULL. The NULL test in the return value check should
be replaced with IS_ERR().
Fixes: a262057df513 ("ASoC: rt1316: Add RT1316 SDCA vendor-specific driver")
Reported-by: Hulk Robot <hulkci@huawei.com>
Signed-off-by: Wei Yongjun <weiyongjun1@huawei.com>
Link: https://lore.kernel.org/r/20210303064041.898281-1-weiyongjun1@huawei.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
This is the initial amplifier driver for rt1316 SDCA version.
Signed-off-by: Shuming Fan <shumingf@realtek.com>
Link: https://lore.kernel.org/r/20210223090759.15323-1-shumingf@realtek.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
