1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
|
* Rockchip rk3399 DMC (Dynamic Memory Controller) device
Required properties:
- compatible: Must be "rockchip,rk3399-dmc".
- devfreq-events: Node to get DDR loading, Refer to
Documentation/devicetree/bindings/devfreq/event/
rockchip-dfi.txt
- clocks: Phandles for clock specified in "clock-names" property
- clock-names : The name of clock used by the DFI, must be
"pclk_ddr_mon";
- operating-points-v2: Refer to Documentation/devicetree/bindings/opp/opp.txt
for details.
- center-supply: DMC supply node.
- status: Marks the node enabled/disabled.
- rockchip,pmu: Phandle to the syscon managing the "PMU general register
files".
Optional properties:
- interrupts: The CPU interrupt number. The interrupt specifier
format depends on the interrupt controller.
It should be a DCF interrupt. When DDR DVFS finishes
a DCF interrupt is triggered.
- rockchip,pmu: Phandle to the syscon managing the "PMU general register
files".
Following properties relate to DDR timing:
- rockchip,dram_speed_bin : Value reference include/dt-bindings/clock/rk3399-ddr.h,
it selects the DDR3 cl-trp-trcd type. It must be
set according to "Speed Bin" in DDR3 datasheet,
DO NOT use a smaller "Speed Bin" than specified
for the DDR3 being used.
- rockchip,pd_idle : Configure the PD_IDLE value. Defines the
power-down idle period in which memories are
placed into power-down mode if bus is idle
for PD_IDLE DFI clock cycles.
- rockchip,sr_idle : Configure the SR_IDLE value. Defines the
self-refresh idle period in which memories are
placed into self-refresh mode if bus is idle
for SR_IDLE * 1024 DFI clock cycles (DFI
clocks freq is half of DRAM clock), default
value is "0".
- rockchip,sr_mc_gate_idle : Defines the memory self-refresh and controller
clock gating idle period. Memories are placed
into self-refresh mode and memory controller
clock arg gating started if bus is idle for
sr_mc_gate_idle*1024 DFI clock cycles.
- rockchip,srpd_lite_idle : Defines the self-refresh power down idle
period in which memories are placed into
self-refresh power down mode if bus is idle
for srpd_lite_idle * 1024 DFI clock cycles.
This parameter is for LPDDR4 only.
- rockchip,standby_idle : Defines the standby idle period in which
memories are placed into self-refresh mode.
The controller, pi, PHY and DRAM clock will
be gated if bus is idle for standby_idle * DFI
clock cycles.
- rockchip,dram_dll_dis_freq : Defines the DDR3 DLL bypass frequency in MHz.
When DDR frequency is less than DRAM_DLL_DISB_FREQ,
DDR3 DLL will be bypassed. Note: if DLL was bypassed,
the odt will also stop working.
- rockchip,phy_dll_dis_freq : Defines the PHY dll bypass frequency in
MHz (Mega Hz). When DDR frequency is less than
DRAM_DLL_DISB_FREQ, PHY DLL will be bypassed.
Note: PHY DLL and PHY ODT are independent.
- rockchip,ddr3_odt_dis_freq : When the DRAM type is DDR3, this parameter defines
the ODT disable frequency in MHz (Mega Hz).
when the DDR frequency is less then ddr3_odt_dis_freq,
the ODT on the DRAM side and controller side are
both disabled.
- rockchip,ddr3_drv : When the DRAM type is DDR3, this parameter defines
the DRAM side driver strength in ohms. Default
value is 40.
- rockchip,ddr3_odt : When the DRAM type is DDR3, this parameter defines
the DRAM side ODT strength in ohms. Default value
is 120.
- rockchip,phy_ddr3_ca_drv : When the DRAM type is DDR3, this parameter defines
the phy side CA line (incluing command line,
address line and clock line) driver strength.
Default value is 40.
- rockchip,phy_ddr3_dq_drv : When the DRAM type is DDR3, this parameter defines
the PHY side DQ line (including DQS/DQ/DM line)
driver strength. Default value is 40.
- rockchip,phy_ddr3_odt : When the DRAM type is DDR3, this parameter defines
the PHY side ODT strength. Default value is 240.
- rockchip,lpddr3_odt_dis_freq : When the DRAM type is LPDDR3, this parameter defines
then ODT disable frequency in MHz (Mega Hz).
When DDR frequency is less then ddr3_odt_dis_freq,
the ODT on the DRAM side and controller side are
both disabled.
- rockchip,lpddr3_drv : When the DRAM type is LPDDR3, this parameter defines
the DRAM side driver strength in ohms. Default
value is 34.
- rockchip,lpddr3_odt : When the DRAM type is LPDDR3, this parameter defines
the DRAM side ODT strength in ohms. Default value
is 240.
- rockchip,phy_lpddr3_ca_drv : When the DRAM type is LPDDR3, this parameter defines
the PHY side CA line (including command line,
address line and clock line) driver strength.
Default value is 40.
- rockchip,phy_lpddr3_dq_drv : When the DRAM type is LPDDR3, this parameter defines
the PHY side DQ line (including DQS/DQ/DM line)
driver strength. Default value is 40.
- rockchip,phy_lpddr3_odt : When dram type is LPDDR3, this parameter define
the phy side odt strength, default value is 240.
- rockchip,lpddr4_odt_dis_freq : When the DRAM type is LPDDR4, this parameter
defines the ODT disable frequency in
MHz (Mega Hz). When the DDR frequency is less then
ddr3_odt_dis_freq, the ODT on the DRAM side and
controller side are both disabled.
- rockchip,lpddr4_drv : When the DRAM type is LPDDR4, this parameter defines
the DRAM side driver strength in ohms. Default
value is 60.
- rockchip,lpddr4_dq_odt : When the DRAM type is LPDDR4, this parameter defines
the DRAM side ODT on DQS/DQ line strength in ohms.
Default value is 40.
- rockchip,lpddr4_ca_odt : When the DRAM type is LPDDR4, this parameter defines
the DRAM side ODT on CA line strength in ohms.
Default value is 40.
- rockchip,phy_lpddr4_ca_drv : When the DRAM type is LPDDR4, this parameter defines
the PHY side CA line (including command address
line) driver strength. Default value is 40.
- rockchip,phy_lpddr4_ck_cs_drv : When the DRAM type is LPDDR4, this parameter defines
the PHY side clock line and CS line driver
strength. Default value is 80.
- rockchip,phy_lpddr4_dq_drv : When the DRAM type is LPDDR4, this parameter defines
the PHY side DQ line (including DQS/DQ/DM line)
driver strength. Default value is 80.
- rockchip,phy_lpddr4_odt : When the DRAM type is LPDDR4, this parameter defines
the PHY side ODT strength. Default value is 60.
Example:
dmc_opp_table: dmc_opp_table {
compatible = "operating-points-v2";
opp00 {
opp-hz = /bits/ 64 <300000000>;
opp-microvolt = <900000>;
};
opp01 {
opp-hz = /bits/ 64 <666000000>;
opp-microvolt = <900000>;
};
};
dmc: dmc {
compatible = "rockchip,rk3399-dmc";
devfreq-events = <&dfi>;
interrupts = <GIC_SPI 1 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&cru SCLK_DDRCLK>;
clock-names = "dmc_clk";
operating-points-v2 = <&dmc_opp_table>;
center-supply = <&ppvar_centerlogic>;
upthreshold = <15>;
downdifferential = <10>;
rockchip,ddr3_speed_bin = <21>;
rockchip,pd_idle = <0x40>;
rockchip,sr_idle = <0x2>;
rockchip,sr_mc_gate_idle = <0x3>;
rockchip,srpd_lite_idle = <0x4>;
rockchip,standby_idle = <0x2000>;
rockchip,dram_dll_dis_freq = <300>;
rockchip,phy_dll_dis_freq = <125>;
rockchip,auto_pd_dis_freq = <666>;
rockchip,ddr3_odt_dis_freq = <333>;
rockchip,ddr3_drv = <40>;
rockchip,ddr3_odt = <120>;
rockchip,phy_ddr3_ca_drv = <40>;
rockchip,phy_ddr3_dq_drv = <40>;
rockchip,phy_ddr3_odt = <240>;
rockchip,lpddr3_odt_dis_freq = <333>;
rockchip,lpddr3_drv = <34>;
rockchip,lpddr3_odt = <240>;
rockchip,phy_lpddr3_ca_drv = <40>;
rockchip,phy_lpddr3_dq_drv = <40>;
rockchip,phy_lpddr3_odt = <240>;
rockchip,lpddr4_odt_dis_freq = <333>;
rockchip,lpddr4_drv = <60>;
rockchip,lpddr4_dq_odt = <40>;
rockchip,lpddr4_ca_odt = <40>;
rockchip,phy_lpddr4_ca_drv = <40>;
rockchip,phy_lpddr4_ck_cs_drv = <80>;
rockchip,phy_lpddr4_dq_drv = <80>;
rockchip,phy_lpddr4_odt = <60>;
};
|
