Merge tag 'spi-nor/for-5.19' into mtd/next

SPI NOR core changes:
- Read back written SR value to make sure the write was done correctly.
- Introduce a common function for Read ID that manufacturer drivers can
  use to verify the Octal DTR switch worked correctly.
- Add helpers for read/write any register commands so manufacturer
  drivers don't open code it every time.
- Clarify rdsr dummy cycles documentation.
- Add debugfs entry to expose internal flash parameters and state.

SPI NOR manufacturer drivers changes:
- Add support for Winbond W25Q512NW-IM, and Eon EN25QH256A.
- Move spi_nor_write_ear() to Winbond module since only Winbond flashes
  use it.
- Rework Micron and Cypress Octal DTR enable methods to improve
  readability.
- Use the common Read ID function to verify switch to Octal DTR mode for
  Micron and Cypress flashes.
- Skip polling status on volatile register writes for Micron and Cypress
  flashes since the operation is instant.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>

1 files changed, 9 insertions, 0 deletions

diff --git a/drivers/pci/controller/pci-hyperv.c b/drivers/pci/controller/pci-hyperv.c
index 558b35aba610..d270a204324e 100644
--- a/drivers/pci/controller/pci-hyperv.c
+++ b/drivers/pci/controller/pci-hyperv.c
@@ -3407,6 +3407,15 @@ static int hv_pci_probe(struct hv_device *hdev,
 	hbus->bridge->domain_nr = dom;
 #ifdef CONFIG_X86
 	hbus->sysdata.domain = dom;
+#elif defined(CONFIG_ARM64)
+	/*
+	 * Set the PCI bus parent to be the corresponding VMbus
+	 * device. Then the VMbus device will be assigned as the
+	 * ACPI companion in pcibios_root_bridge_prepare() and
+	 * pci_dma_configure() will propagate device coherence
+	 * information to devices created on the bus.
+	 */
+	hbus->sysdata.parent = hdev->device.parent;
 #endif
 
 	hbus->hdev = hdev;