spi: dw-spi: Convert 16bit accesses to 32bit accesses

Altera's Arria10 SoC interconnect requires a 32-bit write for APB
peripherals. The current spi-dw driver uses 16-bit accesses in
some locations. This patch converts all the 16-bit reads and
writes to 32-bit reads and writes.

Additional Documentation to Support this Change:
The DW_apb_ssi databook states:
"All registers in the DW_apb_ssi are addressed at 32-bit boundaries
to remain consistent with the AHB bus. Where the physical size of
any register is less than 32-bits wide, the upper unused bits of
the 32-bit boundary are reserved. Writing to these bits has no
effect; reading from these bits returns 0." [1]

[1] Section 6.1 of dw_apb_ssi.pdf (version 3.22a)

Request for test with platforms using the DesignWare SPI IP.

Tested On:
Altera CycloneV development kit
Altera Arria10 development kit
Compile tested for build errors on x86_64 (allyesconfigs)

Signed-off-by: Thor Thayer <tthayer@opensource.altera.com>
Reviewed-and-tested-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

1 files changed, 0 insertions, 10 deletions

diff --git a/drivers/spi/spi-dw.h b/drivers/spi/spi-dw.h
index 41f77e2ccf63..6c91391c1a4f 100644
--- a/drivers/spi/spi-dw.h
+++ b/drivers/spi/spi-dw.h
@@ -150,16 +150,6 @@ static inline void dw_writel(struct dw_spi *dws, u32 offset, u32 val)
 	__raw_writel(val, dws->regs + offset);
 }
 
-static inline u16 dw_readw(struct dw_spi *dws, u32 offset)
-{
-	return __raw_readw(dws->regs + offset);
-}
-
-static inline void dw_writew(struct dw_spi *dws, u32 offset, u16 val)
-{
-	__raw_writew(val, dws->regs + offset);
-}
-
 static inline void spi_enable_chip(struct dw_spi *dws, int enable)
 {
 	dw_writel(dws, DW_SPI_SSIENR, (enable ? 1 : 0));